安装PadWalker之前必须先安装ActivePerl，下载地址为：ActivePerl Downloads
只有安装了padwalker，Eclipse才能调试Perl。
下面介绍padwalker的安装步骤：
1. padwalker下载地址： http://www.bribes.org/perl/ppm/ 2. 解压下载的文件
4. 拷贝 blib/lib/PadWalker.pm 到 Perl/lib（你的安装路径） 5. 拷贝 blib/arch/auto/PadWalker 到 Perl/lib/auto 6. 测试
新建一个*.pl文件，写入以下内容
my $input = <STDIN>; #input from user print $input;
然后在print $input;处设置断点，右击debug as -> perl 即可测试。
下面为原文：
1. Download http://www.bribes.org/perl/ppm/PadWalker-1.6-PPM510.tar.gz 2. Extract the downloaded file to "D:/Download/padwalkerWin/" You can replace the "D:/Download/padwalkerWin" as your folder 3. After extract you will see following folders D:/Download/padwalkerWin/blib 4. Copy D:/Download/padwalkerWin/blib/lib/PadWalker.PM to F:/Perl/lib "F:/Perl" is my perl install folder. you should use your own setting. 5. Copy D:/Download/padwalkerWin/blib/arch/auto/PadWalker to F:/Perl/lib/auto 6. Test your perl in eclipse. #Test.pl my $input = <STDIN>; #input from user print $input; set break point at "print $input;" You should see the input value for $input in variables panel. Above step is tested for EasyEclipse 1.3 + ActivePerl-5.10.0.1002.
