I use
#rpm -i oracle-xe-univ-10.2.0.1-1.0.i386.rpm
to install oracle 10g express edition
after several minutes,something show in terminal:
You must run '/etc/init.d/oracle-xe configure' as the root user to
configure the database.
so i run
#/etc/init.d/oracle-xe configure
then step by step setting up my oracle 10g ed.
"
Oracle Database 10g Express Edition Configuration
-------------------------------------------------
This will configure on-boot properties of Oracle Database 10g Express
Edition. The following questions will determine whether the database should
be starting upon system boot, the ports it will use, and the passwords that
will be used for database accounts. Press <Enter> to accept the defaults.
Ctrl-C will abort.
Specify the HTTP port that will be used for Oracle Application Express [8080]:
Specify a port that will be used for the database listener [1521]:
Specify a password to be used for database accounts. Note that the same
password will be used for SYS and SYSTEM. Oracle recommends the use of
different passwords for each database account. This can be done after
initial configuration:
Confirm the password:
Do you want Oracle Database 10g Express Edition to be started on boot (y/n) [y]:y
Starting Oracle Net Listener...Done
Configuring Database...Done
Starting Oracle Database 10g Express Edition Instance...Done
Installation Completed Successfully.
To access the Database Home Page go to "http://127.0.0.1:8080/apex"
"
http port:
password:
start up while os boot:
port listener
I dont find the datafile location yet.
